Yesterday i bought a JB2 for my ps3 but im having some problems with it. I plug the JB2 in my usb1 and i press reset but the JB2 led just flashes a green light and then it turns off. I alredy tried to upgrade hermes and the upgrader but with no success.
If someone know something about this error and how to fix it i would be very grateful.
If you are on 3.50, the JB procedure will not work; It only works on 3.41 or below. Assuming you are on 3.50, you may need to downgrade it to 3.41 first. Check this out.
If you are on 3.41, ensure your JB files and upgrader are not corrupted. You may want to download another set and do another update just to make sure. Also, there is a proper procedure for JB'ing your PS3. If you're using a slim, you need to remove the power cord, plug in your JB2 device, plug in your power cord then press Power and immediately press Eject. For Fat, you just need to turn off the switch at the back, plug in your JB2 device, press Power and immediately press Eject.
Hope this works for you!!
Edit: For Fat, turn switch off at back, plug in your JB2 device, turn switch on then press Power and immediately press Eject.
Last edited by JedTanner; 12-21-2010 at 09:02 AMReason: Automerged Doublepost
I know it sounds like a stupid question, but are you sure you are doing it right? The dongle shouldn't light up as soon as you plug it in, since the PS3 should be powered off. Follow JedTanner's post above exactly as it says. If this doesn't work then it's possible you have a bad payload.