hey, the title says it all, i plan to install prokskeet onto my 60gb fat console (dual nand)
has anyone got a diagram, so i can tell what wires go to what nand (i want to solder directly to nand legs btw, i have to learn to solder at some point. i am not intrested in the clips)
i have got the following equipment, so tips tricks general advice/help is needed.
15w fine tip soldering iron
lead free solder (fine)
60/40 leaded solder (fine)
solder paste (flux & paste)
dremal hot air soldering iron
30awg kynar (multi colours, want a pretty install)
no clean liquid flux
regular flux (paste)
hot glue gun
any help will be great, is it possible to use paste/hot air?
i have read that i shouldnt be using test points on the 60gb dual nand and need to solder to legs directly
so if you can help please do, i am looking in the general directions of mushy and idone also
e3 use only nor, progskeet flash nor end nand. look at this link: ps3devwiki.com/index.php?title=Hardware_flashing#Progskeet
Other people haven't been sitting idle either: uf6667 and xxxx have developed Progskeet, based on a Actel A3P125 MCU for NAND and NOR based consoles (not only PS3, but also useable for Wii and Xbox360).
put switch in "OFF" (R7 is open) position so that progskeet is not powered.
power on the ps3 and wait for 20-25 seconds, put the switch in the "ON" (R7 closed) position, so progskeet is powered and will be recognized by the PC.
NAND is always on now, do everything as usual
select Big Block
Pages per block: 64
That will give you 132MB (138,412,032 bytes) per NAND (dump time ~ 00:02:40 per NAND)
For normal console operation (e.g. after you dumped, flashed/downgraded it): you need switch to "on" (R7 closed) and progskeet USB disconnected