[Answered] Infectus v2 waninkoko brick please help?
i have a ps3 with bricked firmware (when i press power, after 5sec get yled and after a sec red led blinking) i have install infectus v2 but the flash0/flash1 are not available
i have not any dump. i can't make dump/flash from any tool (i have try infectus NAND flasher 188.8.131.52, InfectusPorgrammer 184.108.40.206-220.127.116.11 and PS3NANDProgrammer1_41)
please help me to unbrick my ps3
Looks like you got the YLOD, there are many guides here and on google on how to fix it yourself or you can pay a professional to fix it for you.
There are too many guides and procedures on how to fix the YLOD, I don't know which one to send you. Do a bit of searching and if you see a good guide you want to try we can certainly help you with it or give you our suggestions.
its the 60gb model and the brick comes after install of waninkoko firmware... i follow the guide to fix but i have the problem with flash0/flash1...
If you cannot see either flash, check your soldering for shorts/dry-joints, and make sure your Infectus is setup for PS3 Dual NAND.
From experience I would definitley say re-do ALL your soldering. Use fresh wire & plenty of flux to solder your connections.
If you can't access the NANDs then you have a connection problem...
Are you checking with some magnifier or just with the naked eye?
The pitch of those pins is 0.5mm and it only takes a tiny solder ball/bridge to completely ruin your morning!!
Put it under a microscope if you can.