Infectus v2 waninkoko brick please help?

[xameleon]

i have a ps3 with bricked firmware (when i press power, after 5sec get yled and after a sec red led blinking) i have install infectus v2 but the flash0/flash1 are not available

i have not any dump. i can't make dump/flash from any tool (i have try infectus NAND flasher 1.0.4.2, InfectusPorgrammer 3.9.8.0-3.9.9.0 and PS3NANDProgrammer1_41)

please help me to unbrick my ps3

[HeyManHRU]

Looks like you got the YLOD, there are many guides here and on google on how to fix it yourself or you can pay a professional to fix it for you.

[xameleon]

can you send me a guide?

[HeyManHRU]

There are too many guides and procedures on how to fix the YLOD, I don't know which one to send you. Do a bit of searching and if you see a good guide you want to try we can certainly help you with it or give you our suggestions.

[xameleon]

its the 60gb model and the brick comes after install of waninkoko firmware... i follow the guide to fix but i have the problem with flash0/flash1...

[zetski210]

If you cannot see either flash, check your soldering for shorts/dry-joints, and make sure your Infectus is setup for PS3 Dual NAND.

[xameleon]

i can see the flash but shows them as unknown. i haven't access for read/write. i have setup the dual nand from infectus tool and i have check all the solderings and its ok

i have a second board 60gb with the same problem (waninkoko brick)

can i solder the infectus there or i will have the same result(no read/write)? have anyone successful fix him ps3 without dump before waninkoko brick?

thanks for all

[mushy409]

From experience I would definitley say re-do ALL your soldering. Use fresh wire & plenty of flux to solder your connections.

If you can't access the NANDs then you have a connection problem...

[zetski210]

Are you checking with some magnifier or just with the naked eye?

The pitch of those pins is 0.5mm and it only takes a tiny solder ball/bridge to completely ruin your morning!!

Put it under a microscope if you can.