[Answered] e3 flash/hdmi or vga help?
i have put the 2504B 1A put aside and lucky enough got my hands on a FAT CECHL04-- OFW 4.00
i've made the E3flasher installation and must say it went pretty good first try the softboard was just a bit to short to fit on tfboard heh
anyway, i have it connected via HDMI, now i thought i read you must use VGA instead for downgrading? or does HDMI works?
at least it boots fine installation correct
alright, HDMI is only when entering factory/service mode, then there is no screenoutput, form normal operation its no problem?
really, excuse all the questions guys, so many info, its hurting my brain...
btw, i try to load all "psgrade.hex" files, the x2tool log shows: File does not contain valid descriptor,please try another hex
not supported i guess, really need another dongle for this, or is there a hex file floating arround?
Last edited by haze67; 12-25-2011 at 07:33 PM Reason: Automerged Doublepost
Ok from my experience most of the time that you get that message you have a problem that it is not hooked up right. When I first used my e3 I had to bend all the bins out a little on the clip. Try to reinstall it and see what happens. Thanks