Bricked PS3 need help where to solder?

[geeklogik]

Hey guys bricked ps3 should I don't want to solder tristate to sbe. I am confused whether to solder to 3.3v VCC or the GND. Can you please help out. I bricked by flashing a rogero auto-patched dump. My dumps are good and have been verified by myself and others.

[technodon]

i'm guessing its progskeet that you have? i think its GND.. might want a 2nd opinion though

[geeklogik]

sorry its an e3 flasher.

anyone please desperate!

[racer0018]

Tell us what motherboard you have in your ps3. Thanks

[geeklogik]

jtp-001 all i need is to know where to solder 3.3V vcc or gnd, i know where both points are

also can someone also state steps after soldering to unbrick? thanks !

[pinkone]

You can use the point on the flatcable or I use the one in the pic.

Then to unbrick put your dump on the sdcard and set switch 1 up and the rest down after it's done flashing unplug the ps3 and set switch 1 down and you should be back where you started. I'd then use the e3_downgrade.bin to do your downgrade to 3.55.

[geeklogik]

thanks guy figured it out myself, you have to cut gnd to tristate wire after you flash with your orig dump. then boot and wallah

thanks anyways, pls close thread!