i used this file: http://www.ps3news.com/forums/attach...chmentid=21129
in the makefile change F_CPU to 8000000 change MCU to at90usb162
open a command line and go to the directory with the makefile
type "make clean"
afterwards there should be a file called psgroove.hex in the directory
Will the AT90USB162 with only 16kb of flash memory be big enuff to store psgroove or will i need one with memory?
I found a place where I can buy an olimex at90usb162. Which one of these two will work?
Only the second one is availible, but I'm not sure if it will work.
it has been confirmed a few times that this chip will work
the code does really not need much, just a controller with free programmable usb as it uses own id´s . the atmels are able to habe 6 ids with each its own buffer. and more they dont use - besides the led, which is obselent.