PS3Jig v1.00 PS3 Factory / Service Mode Jig Dongle for Sony PSP

[Desu]

Natepig, you should:

1. Take out the power cable from the back of ps3
2. Start Pspjig on the psp.
3. Put it back in and immediately press power then eject very quickly on ps3

[Nabnab]

Thanks Desu

[peshellas]

guys really listen this auto turn on feature CAN be turned off and most slims don't have it i'm on 3.55 with mine and it doesn't have it (without turning it off through rebug). also i actually ENABLED it on my phat 40gb ps3 so its just a debug setting, that if you use rebug you can turn it off just see in the debug settings of rebug mates.

[Nabnab]

Official FW

Or maybe it come with the 2504B

[peshellas]

oh ok sorry mate didn't know, anyway again for the last time can you pm me an irc to talk about something? if not i'm gonna get back to my research but i have found some interesting things and would like to ask some more info about something.

[Natepig]

Ok its clear to me now but I can tell you that the ps3 slim on ofw 4.0 does not try to turn on itself once the power cable is reinserted. I get the same result as before. I'm going to test ps3jig on my slim kmeaw 3.55 to check and see if the psp side of it is ok for me. Back in 10 mins.

[Nabnab]

If it doesn't work, you gonna test another one, this one should work only on firmware 4.0

[cfwprophet]

I will contact you in a few.

[Natepig]

O.k. it worked fine on the kmeaw 3.55 slim and I got the following readout on the psp:

Challenge Recieved: 00 01 FF FF 2E 02 01 52 01 46

Sending response: 00 00 FF 00 2E 02 02 AA AA 19

Sent Response: 00 00 FF 00 2E 02 02 AA AA 19

I do exactly the same steps on the 4.0 slim which is the exact same model as my 3.55, but I get nothing from it other than hanging for a bit at boot.

[Nabnab]

Ok stay not far, i put online a second PS3jig that suppose to only work on the firmware 4.0