i think it's working now after i've done...
chmod +x ./psfreedom-enable.sh
once i go home i'm gonna try it for sure.
How do I "then ssh into your N900 and type : ./psfreedom-enable.sh " make this step with WinScp?
You're maximally in a process of blowing up USB ports on your PC as well as PS3 is you're brave (read DUMB) enough to connect them directly with A - A USB cable...
I followed the next steps:
- Open xterminal.
- type: sudo gainroot (you must have installed 'Rootsh'. available throug maemo.org)
- type ssh localhost (i've installed 'OpenSSH'. also available throug maemo.org)
password: use the password you did set while installing OpenSSH or if you did not set a password use: rootme
now you can type: ./psfreedom-enable.sh
If you get a permission denied fault:
chmod +x psfreedom-enable.sh
chmod +x psfreedom-disable.sh
And try ./psfreedom-enable.sh again
I finaly did managed to install the backup manager on my ps3 and to make some backups. Sadly I'm still not be able to start a backuped game.
How about the old iPAQ? It can run linux and act as USB device.
Any idea what is the usb chipset there?
As it's a linux kernel module, I wonder if we can add it to the ported linux 2.6 kernel and with little changes to run it on the iphone, thro the OpeniBoot terminal (with auto script of curse).
we can port it even to ipodlinux (that runs on the ipod video) - it's also got a linux kernel 2.4, and we can easly run linux kernel modules.
here is howto of "Hello World" module: http://ipl.derpapst.eu/wiki/Hello_World_Module