Hi, can someone tell me please how i can repack the nor folders to a .bin. I had my backup from my slim the only corrupted data is bootloader_0. i want replace it from another ps3 and repack it with my folders to a bin and flash it to my ps3.
i have been reading this cause i have a bricked ps3 slim that i downgraded from 4.31 OFW to 3.55 i used a flasher, everything went successful after downgrade when i reboot the ps3 it went to the XMB after a failed attempt of De-hashing my ps3 is bricked.
i tried this tut everything went ok as to how it was explained but after i re flash my dump and downgraded again back 3.55 my ps3 wont boot the TV screen is just blank and the power button doesn't work if i try to reset, i don't know what am doing wrong are if my bios dump is bad (which is the dump made from the 4.31 ofw thats the only one i made) am new to all this flashing stuff if guys could help me.
Thank you for this tutorial. I just have one question. You're saying to push the reset button 3 times. Where is the RESET button!!? on the TF board there is a START,a STOP in addition to the 6 switches and on the PS3, there are EJECT and OFF/ON buttons. I can't find the RESET button. Thank you for your time.
RESET is on the board.next to where you put the cable from the nor clip but i don't get this tutorial.. it makes no sense to use his backup as it dosen't work on your console.
if you have a working backup. solder a wire from sbe to tristate on ps3. put your backup on tf card and attach it. set switches to up. down, down, down, down, down
your console is now working again. remove the wire from tristate. turn console on to see if its working. if yes then go on. patch your dump with downgrade files and put on tf card and delete all other files first. remember to keep you original dump somewhere safe. put switches all down and flash console and follow rest of the normal guide.
this also works if your console is dead after a firmware upgrade and you dont have a working dump. solder wire to tristate then first make a dump ore several and compere them. you can't verify the dump as it is all messed up. patch your dump with downgrade files and put on tf card.
remember to keep your dump safe. put switches all down and flash console and follow rest of the normal guide. at last after downgrading make a new dump use multiman and now you know that you have a fully workin dump again.
I have done this to 3 consoles and they are all working normal again.