hello all... I have 3 bad blocks after nand0 dump using infectus double nand programmer v1.41. Tried 6x with the same results. No issues with nand1. When I use the infectus programmer, i don't receive any errors for both nands. I checked the wiring many times and the solder points are good. Before I proceed, could someone provide some insight. (wanikoko v1 brick)
Below is the error log report for nand 0. If needed, i will upload the files for further review...
Code:
------------------------------------------------------------------------
START DUMP READING PROCESS: 08/21/12 (20:57:18) - PS3 DNP 1.41
------------------------------------------------------------------------
> Read cycle #629/1024, NAND Bad Block #1 found at Address: 84885504 (dec)
> Read cycle #832/1024, NAND Bad Block #2 found at Address: 112324608 (dec)
> Read cycle #916/1024, NAND Bad Block #3 found at Address: 123678720 (dec)
> Flash0 NAND dump saved on file: C:\Users\Sal\Desktop\flash0 bk
------------------------------------------------------------------------
END DUMP READING PROCESS: 08/21/12 (21:12:37)
------------------------------------------------------------------------
------------------------------------------------------------------------
START DUMP READING PROCESS: 08/21/12 (21:54:29) - PS3 DNP 1.41
------------------------------------------------------------------------
> Read cycle #629/1024, NAND Bad Block #1 found at Address: 84885504 (dec)
> Read cycle #832/1024, NAND Bad Block #2 found at Address: 112324608 (dec)
> Read cycle #916/1024, NAND Bad Block #3 found at Address: 123678720 (dec)
> Flash0 NAND dump saved on file: C:\Users\Sal\Desktop\flash0 bk1
------------------------------------------------------------------------
END DUMP READING PROCESS: 08/21/12 (22:09:48)
